3.0 KiB

Raw Blame History

How to set up 01 on a Raspberry Pi

Supplies needed

Raspberry Pi 5
Micro SD Card
USB-C cable
Micro HDMI to HDMI cable
Monitor
Keyboard
Mouse
USB Microphone (like this one)
USB or Bluetooth speaker
Breadboard, jumper wires, 220R resistor and button (a kit like this one has everything you need)

SD card setup

Flash a new sd card using Raspberry Pi Imager
- Pick your device (only tested on Raspberry Pi 5)
- Select the OS: Scroll down to "Other General OS" Then select Ubuntu Desktop 64bit
- Select the storage: Select your sd card
- Proceed to flashing by selecting "Write"

Hardware set up

Connect Raspberry pi board to USB-C power
Connect a keyboard, mouse, and mic to the USB ports
Connect a monitor to the micro HDMI port
Insert your newly flashed SD card into the slot under the device by the power button
Power it on with the power button
Hook up the Button to the breadboard,it should look like this:

Ubuntu set up

Go through the system configuration on start up:
- Make sure to connect to wifi, we will need it to install 01 and it's packages
- Choose a password you will remember, you will need it later
Open terminal
sudo apt update && sudo apt upgrade -y
- Sometimes dpkg will complain, if it does, run sudo dpkg --configure -a and then run the update and upgrade commands again

Clone the repo:

sudo apt install git -y
git clone https://github.com/KillianLucas/01
cd 01/OS/01/

Set up a virtual environment:

sudo apt install python3-venv -y
python3 -m venv venv
source venv/bin/activate

Install packages:

sudo apt install ffmpeg portaudio19-dev (ffmpeg and portaudio19-dev need to be installed with apt on linux)
sudo apt-get update
sudo apt-get install gpiod
pip install -r requirements.txt
pyaudio install might fail, these commands should fix it:
- sudo apt-get install gcc make python3-dev portaudio19-dev
- pip install pyaudio

Rename and edit the .env file:

mv .env.example .env (rename the .env file)
Add your OpenAI key to the .env file, or by running export OPENAI_API_KEY="sk-..."
- To add it to the .env in the terminal, run nano .env
- Add the key to the OPENAI_API_KEY line
- Save and exit by pressing ctrl + x, then y, then enter

Run the start script:

bash start.sh
- There may be a few packages that didn't install, yielding a 'ModuleNotFoundError' error. If you see this, manually install each of them with pip and retry the bash start.sh command.

Done! You should now be able to use 01 on your Raspberry Pi 5, and use the button to invoke the assistant.